Advertisement
送布⽛的傾斜
⽛架軸（1）與水平送布台臂（3）的標準
為：⽛架軸（1）的配合標記（2）與水平
送布台臂（3）的基線（4）一致
1. 放下縫紉機頭
2. 旋松固定螺釘（5）
3. 將螺絲刀伸⼊⽛架軸（1）的槽（6）內 ,
轉動並進行調整
4. 擰緊固定螺釘（5）
●根據布料的不同需調整送布⽛的傾斜
時，調整好送布⽛的傾斜後，送布⽛前
後位置會發生變化，旋松螺釘（7）以
機針為基準針調節送布⽛前後位置
●調整送布⽛的傾斜，送布⽛的高度會發
生變化，請重新調整送布⽛的高度
Feed dog angle
1.The standard angle for the feed dog is when the mark (2) on the
feed bar shaft (1) is aligned with the reference line (4) on the
feed rocker base arm (3).
2.Loosen the set screw (5).
3.Insert a screwdriver into the slit (6) in the feed bar shaft (1), and
turn it to make the adjustment.
4.Tighten the set screw (5).
● When the angle of the feed dog is adjusted, the forward-back
position of the feed dog will change. Loosen the two screws
(7) and adjust the forward-back position of the feed dog in
accordance with the needle.
● In addition, when the angle of the feed dog is adjusted, the
height of the feed dog will also change, so readjust the height
of the feed dog.
P27
Advertisement
