Advertisement
①送布⽛的安裝方法
1. 將送布⽛（1）用螺釘（3）安裝在⽛
架叉組件（ 2）上
2. 擰緊送布⽛叉組件的固定螺釘（4），
使其前端與送布⽛（1）的下面接觸
3. 擰 緊 螺 母（5）， 固 定 螺 釘（4） 不
能將送布⽛傾斜著固定在⽛架叉組件
（2）上
②送布⽛的位置
前後位置調整
就 算 針 桿 和 壓 腳 桿 的 間 隔（13.3-
13.7mm）正確，針和送布⽛針孔的位
置關係不好時，也需進行調整
1. 旋松螺釘（1）
2. 轉動水平送布台臂進行調整，使機針
在送布⽛（2）的針孔中心位置。
3. 擰緊螺釘（1）
※ 請不要過度擰緊螺釘（1）, 會導致水
平送布台臂（3）的破損。
左右位置的調整
用螺釘（5）和（6）將針板（4）固定
在底板上，以此時針板的位置為基準，
調整送布⽛左右位置，使送布⽛各側面
與針板无接觸
針板與送布⽛接觸時，旋松螺釘（1）,
左右移動水平送布台臂（3）進行調整
①
① Installing the feed dog
1.Install the feed dog (1) to the feed bar (2) with the two screws
(3)
2.Tighten the feed dog support set screw (4) so that the tip of
the set screw (4) touches the bottom of the feed dog (1)
3.Tighten the nut (5) to secure the set screw (4). The set screw (2)
is not used for installing the feed dog at an angle
② Feed dog position
Forward-back position adjustment
Carry out this adjustment if the needle and the needle hole
in the feed dog are not positioned correctly even though the
clearance between the needle bar and the presser bar (13.3-13.7
mm) is correct
1.Loosen the two screws (1)
2.Turn the feed rocker base arm (3) to adjust so that the needle
drops into the middle of the needle hole in the feed dog (2)
3.Tighten the screw (1)
※Do not overtighten the screw (1), otherwise it will damage the
feed rocker base arm (3)
Left-right position adjustment
Adjust so that neither side of the feed dog touches the needle
plate (4) when the needle plate (4) is secured to the bed with
the screws (5) and (6)
If the needle plate and the feed dog are touching, loosen the
screw (1) and move the feed rocker base arm (3) sideways to
adjust
②
P25
Advertisement
