Advertisement
保養
注意
在開始清潔作業前，請切斷電源。
當誤按動開關時，縫紉機動作會導致人員
受傷。
使用潤滑油和⻩油時，務必戴好保護眼睛
和保護手套等，以防潤滑油落⼊眼中或沾
在皮膚上，會引起發炎。
縫紉機頭倒下時，請一定要固定工作台，
不可使其隨意移動。
工作台移動易發生腳等被夾住等事故。
縫紉機頭倒下或豎起時 ， 請用雙手進行操作 。
單手操作時因縫紉機自身的重量，萬一滑
落易導致受傷。
日常清潔
為了保持縫紉機的機能，而且能長久的使
用，請每天進行日常保養。
另外，縫紉機如果長時間未使用，請在進
行瞭如下的保養後在使用。
保養
1. 轉動手輪，將機針置於最高位置
2. 將左右推板按圖示方向打開
3. 取出梭芯
4. 清除旋梭內的線頭等雜物
5. 安裝好梭芯
6. 左右推板恢復到以前位置
補充機油
當潤滑油的液位下降到油量計視窗（1）
的下基線（2）以下時，應添加潤滑油。
CLEANING
CAUTION
Turn off the power switch before carrying out claning
The machine may operate if the treadle is depressed by istake,
which could result in injury.
Be sure to wear protective goggles and gloves when handling the
lubricating oil and grease, so that they do noe get into your eyes
or onto your skin, otherwise inflammation can result.
Secure the table so that it will not move when tilting back the
machine head.
If the table moves, it may crush your feet or cause other injuries.
Use both hands to hold the machine head when tilting it back it to
its original position.
IF only one hand is used, the weight of the machine head may
cause your hand to slip, and your hand may get canght.
Daily cleaning procedures
The following cleaning operations should be carried out each
day in order to maintain the performance of this machine and to
ensure a long service life.
Furthermore, if the sewing machine has not been used for a long
period of time, carry out the following cleaning procedures before
using it again.
Cleaning
1.Turn the machine pulley to move the needle to the needle up
stop position
2.Open the slide plates at the left and right
3.Remove the bobbin
4.Clean the thread scraps from the rotary hook
5.Install the bobbin and the bobbin case
6.The left and right push plates return to their former position
Filling the oil tank
If the lubricating oil level drops below the botton reference line (2)
of the oil gauge window (1), be sure to add more oil.
P17
Advertisement
