Other Parameters - Epever IPT Series User Manual

Step3: Click the
 Click the
 Click the
 Press and hold the
value will increase by 100 each time. When the
again to repeat the above operation. Note: The setting parameter cannot exceed the user
define, or else; it will return to the initial value to start the loop.
Step4: Press and hold the
3) Set the power to enter the power saving mode (PSI)
Step1: In the parameters setting interface, click the
Step2: Press and hold the
Step3: Click the
 Click the
 Click the
 Press and hold the
value will increase by 100 each time. When the
again to repeat the above operation. Note: The setting parameter cannot exceed the user
define, or else; it will return to the initial value to start the loop.
Step4: Press and hold the

6.2 Other parameters

Users can set the baud rate, output voltage class and output frequency class, etc. by the remote meter.
Operation:
Step1: In the real-time interface, press
Step2: Click or
or button to set the PSO parameter.
button to decrease the PSO value by 1.
button to increase the PSO value by 1.
button to increase the PSO value by 10. After ten adding, the PSO
button to confirm.
button until the PSI value flashes.
or button to set the PSI parameter.
button to decrease the PSI value by 1.
button to increase the PSI value by 1.
button to increase the PSI value by 10. After ten adding, the PSI
button to confirm.
to select the parameter to be configured.
or
for 2s to enter the parameter setting interface.
22
button is released, press and hold it
button to select the PSI parameter.
button is released, press and hold it