Table of Contents
Advertisement
Testing Film Samples
2.
Open the Cartridge Tray completely by gently pulling straight back from the front panel.
3.
Grasp the Test Cartridge by the front and back edges and lift straight up.
To Load the Test Cartridge into the instrument, follow the instructions below (refer to Figure 6-4 and 6-5):
1.
Grasp the Test Cartridge by the front and back edges and lower it straight down.
2.
Close the Cell Cartridge completely by gently pushing straight towards the front panel.
3.
Keep your finger holding the tray at its closed position.
4.
While holding the Cell Tray, press the Cell Load/Unload button to clamp the cell (see Figure
6-4).
6-10
Figure 6-4: Loading the Test Cartridge
Revision G
AQUATRAN 3/38 Operator's Manual
MOCON, Inc.
Advertisement
Table of Contents
