Ametek mocon AQUATRAN 3/38 Operator's Manual page 32

Calibrating the Permeant Sensor AQUATRAN 3/38 Operator's Manual
Calibration of the permeant (water vapor) sensor is a two-step process. First, a film sample with a known
transmission rate must be tested. Refer to the "Permeant Sensor Calibration Test Setup" in this chapter for
information on setting up a film test. The data from the test can then be used to adjust the permeant sensor.
After suitable data is available the "WVTR Calibration" screen can be used to adjust the output of the
Permeant Sensor. Refer to the Instrument Help System for more information on performing a WVTR
Calibration.
After a WVTR Calibration has been made and saved it can be viewed and recalled using the Calibration
History screen. Refer to the Instrument Help System for more information on using the Calibration History
screen.
5-2 Revision G MOCON, Inc.