Table of Contents
Advertisement
AQUATRAN 3/38 Operator's Manual
About This Manual
This manual explains how to set up and use the AQUATRAN 3/38 Water Vapor Transmission Rate System.
This manual is designed for viewing electronically. Most references to other sections or chapters in this
document are hyperlinks which can be used to navigate to the referenced section.
Please use the following guide to get started with the system.
If You Want to Set Up the AQUATRAN 3/38
1.
Prepare your test site.
See Appendix A "Site Preparation Instructions" starting on page A-1 in this manual.
2.
Install the AQUATRAN components.
See Chapter 2 "Setting Up" starting on page 2-1 in this manual.
If You Want Some Background on How the System Works:
1.
Get an overview of the system.
See Chapter 1 "Introduction" on page 1-1 in this manual.
2.
Learn how the AQUATRAN measures water vapor transmission.
See Appendix D "Theory of Operation" on page D-1 in this manual.
3.
Learn about the software.
See Chapter 4 "Using the Instrument Software" starting on page 4-1 in this manual.
If You Want to Get Started Measuring Water Vapor Transmission Rate:
See Chapter 3 "Preparing for a Test" beginning on page 3-1, Chapter 6 "Testing Film
Samples" on page 6-1.
If You Have Problems Operating the System:
1.
If an error message appears on the instrument screen see Chapter 8 "Troubleshooting"
beginning on page 8-1 in this manual.
2.
If no error message appears but you have other problems, see Chapter 8 "Troubleshooting"
beginning on page 8-1 in this manual.
SERVICE NOTE:
Please do not hesitate to call MOCON in the USA at (763) 493-6370. We want you to receive the
best in product support services.
MOCON, Inc.
Revision G
About This Manual
iii
Advertisement
Table of Contents
