Enabling Quicklock - Compaq Deskpro AP400 Reference Manual

3-18 Security Features

Enabling QuickLock

QuickLock is enabled through Security Management in Computer Setup. This
feature allows you to disable the keyboard and mouse interface.
NOTE: To re-enable the keyboard and mouse interface and access the
application, you must enter the Power-on Password that you established in
Security Management. Therefore, you must establish a Power-on Password in
order to utilize QuickLock.
To enable the QuickLock feature, the Power-on Password must be enabled.
Then:
1. Turn on the workstation.
2. When you see the words "F10=Setup" in the bottom-right corner of the
screen, press F10.
NOTE: You have approximately two seconds to press F10. If you do not press
F10 during this time, you must turn the workstation off, then on again to
access the utility.
3. Press Enter to bypass the welcome screens and display the main menu.
4. From the main menu, select Computer Setup, then press Enter.
5. From the Computer Setup main menu, select the Security Management
feature under Built-In Devices.
6. Select Enable QuickLock of the Keyboard to enable the Initiate
QuickLock When Entering Energy Saver Modes.
NOTE: In order to use Initiate QuickLock when entering Energy Saver Mode,
the Power Management option must be enabled.
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
File Name: D-CH03.DOC Last Saved On: 12/17/98 1:36 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED