Reconfiguring The Workstation; Running Computer Setup - Compaq Deskpro AP400 Reference Manual

1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Open the workstation by removing its outside cover and front bezel. See
the sections "Removing the Workstation Cover" and "Removing the
Front Bezel" in this chapter for instructions.
3. Install any optional equipment (ISA or PCI expansion board, or
Accelerated Graphic Port (AGP) graphics controller, processor upgrade,
memory, or drive). See the applicable chapters in this manual or the
documentation provided with the optional equipment for instructions.
4. Replace the front bezel and workstation cover.
5. Reconnect the power cord to the back of the workstation, and plug in the
power cord to a grounded AC outlet.
6. Turn on the monitor, workstation, and any devices you installed.
7. Reconfigure the workstation, if necessary. See Chapter 2 for
instructions.
8. Test the workstation (optional) using the TEST utility.

Reconfiguring the Workstation

System configuration is the process of specifying the devices and programs that
make up a system. When you add or remove optional equipment, you must
reconfigure the workstation by running Computer Setup in order for the
changes to be recognized.
Run the Computer Setup utility after you complete the installation. To
configure in Windows NT, utilize Control Panel and configure your specific
option.
If configuration settings are incorrect, one or more devices may not work
properly, and you may receive an error message. If this occurs, run the
Computer Setup utility again. See Chapter 2 for more information on Computer
Setup.
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
File Name: H-CH07.DOC Last Saved On: 12/10/98 11:33 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP400 Reference Guide
7-3