Quicklock/Quickblank - Compaq SP700 Reference Manual

QuickLock/QuickBlank

QuickLock/QuickBlank disables the keyboard and mouse interface, and can
blank the screen, without exiting open applications.
IMPORTANT: You must set a Power-on Password before you can enable
QuickLock or QuickBlank. For more information, see the section
"Establishing a Power-on Password Using Computer Setup" in this chapter.
Enabling QuickLock and QuickBlank
1. Turn on or restart the workstation.
2. When you see the words "F10=Setup" in the bottom-right corner of the
screen, press the F10 key.
NOTE: If you do not press the F10 key while the message is displayed, you
must turn off the workstation, then on again, to access the utility.
3. From the main menu, select Security, then select Password Options.
4. To enable QuickLock, press the up/down arrow keys to move the
Keyboard Quicklock selection, then use the left/right arrow keys to
select Enable.
This displays the QuickLock and QuickBlank options:
5. Save the configuration and exit the utility.
6. Restart the workstation.
To enable QuickBlank, press the up/down arrow keys to move the
QuickBlank Screen When Locked selection, then use the left/right
arrow keys to select Enable.
To enable Quicklock in Energy Saver mode, press the up/down
arrow keys to move the Quicklock in Energy Saver Mode selection,
then use the left/right arrow keys to select Enable.
Compaq Professional Workstation SP700 Reference Guide
3-15