Compaq Deskpro AP400 Reference Manual page 102

9-8 Drives
NOTE: Some options use M3 metric thread hardware. Extra guide screws are
provided on the front of the chassis, behind the front bezel. The Compaq-
supplied metric screws are black.
Figure 9-9. Connecting the signal and power cables
NOTE: If you are installing an additional Ultra ATA (IDE) drive, you should
replace the existing 40-conductor cable with the 80-conductor cable provided
in the option kit. This new cable will ensure optimum drive performance.
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
CAUTION: Do not route cables near the air intake of the power
supply. Cables routed in this manner may block airflow to the
power supply causing it to overheat.
File Name: J-CH09.DOC Last Saved On: 12/14/98 1:33 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED