Compaq Deskpro AP400 Reference Manual page 150

D-2 POST Error Messages
POST Error Messages and Codes
Error Code
172-1 Configuration
Nonvolatile Memory
Invalid
201-Memory Error
202-Memory Type
Mismatch
203-Memory Address
Error
205-Memory Error
207-ECC Corrected
Single Bit Errors in
DIMM/SIMM Pair(s)
210-Invalid Memory
Configuration Detected.
Maximun of 1 gigabyte
of memory supported.
System halted
212-Failed Processor
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
Continued
Probable Source
of Problem
NVRAM Configuration error
RAM failure
RAM failure
RAM failure
Cache memory error
A memory error on one of
the installed DIMMs has
been detected and
corrected with the
system's ECC logic. The
workstation will continue
to operate correctly with
this error.
Too much memory
installed.
Failed processor
(X is 0 or 1)
File Name: Q-APPD.DOC Last Saved On: 12/14/98 1:55 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Action
Allow system to complete boot.
Reboot.
If condition persists, contact
your Compaq authorized service
provider.
Contact your Compaq
authorized service provider.
Contact your Compaq
authorized service provider.
Contact your Compaq
authorized service provider.
Run the Computer Checkup or
Diagnostics utility.
Run Diagnostics to get more
information; then contact your
Compaq authorized service
provider.
Reduce memory installed by
removing DIMMs.
Contact your Compaq authorized
service provider.
Continued