Enabling Quicklock/Quickblank - Compaq PW5100 Reference Manual

Enabling QuickLock/QuickBlank

QuickLock and QuickBlank are enabled through Security Management in
Computer Setup. These features allow you to:
Disable the keyboard and mouse interface (QuickLock)
Blank the screen from within an application (QuickBlank)
NOTE: To re-enable the keyboard and mouse interface and access the
application, you must enter the Power-On Password that you established in
Security Management. Therefore, you must establish a Power-On Password in
order to utilize QuickLock and QuickBlank.
To enable the QuickLock and QuickBlank features, the Power-On Password
must be enabled. Then:
1. Turn on the workstation.
2. When the cursor appears in the upper-right corner of the screen, press
F10.
NOTE: The cursor displays in the upper-right corner of the screen for
approximately two seconds. If you do not press F10 during this time, you must
turn the workstation off, then on again to access the utility.
3. Press Enter to bypass the welcome screens and display the main menu.
4. Select Computer Setup from the main menu and press Enter.
5. From the Computer Setup main menu, select the Security Management
feature under Built-In Devices.
6. Select Enable QuickLock of the Keyboard to enable the QuickBlank the
Screen When Locked and Initiate QuickLock When entering Energy
Saver Modes.
NOTE: In order to use Initiate QuickLock when entering Energy Saver Mode,
the Power Management option must be enabled.
Compaq Professional Workstation 5100 Reference Guide
3-15