Starting A Telnet Session; Using Vt-100 Terminal Emulation - ADTRAN ATLAS 800 User Manual

Chapter 3. Operating the ATLAS 800

Starting a Telnet Session

Using VT-100 Terminal Emulation

3-4
Instructions for Setting the Gateway IP Address
Step
From the Front Panel, select 2) CONFIG , then S0) SYSTEM , then
1
1) ETHERNET .
2 When the submenu displays, select 3) DEF GATEWAY .
Enter the default gateway by entering each number followed by
3
Enter to move to the next field.
4 Press Enter after keying in the entire address.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.
When you begin the Telnet session, you will be prompted for a password.
The default password is password (which is a Level 0 superuser password).
You can change this password using the Access Passwords option, which
is only accessible through the terminal menus. See Access Passwords on page
6-11 for details. The Telnet session will time out and display the Login
prompt after a pre-defined time that is set in the Session Timeout option
(see Session Timeout on page 6-7 for details).
Use the Max Telnet Sessions option to define the number of Telnet
sessions that can be active at one time (see Max Telnet Sessions on page
6-7 for details).
Microsoft Telnet version 1.0 does not implement full VT-100 emulation.
However, many commercial Telnet clients for Microsoft Windows exist
which fully implement VT-100. In addition, a freeware client which is
recommended for optimum performance is delivered with the
ATLAS_800. See VT-100 Utility on page 12-7 for details.
For detailed information on the commands available during a Telnet ses-
sion, refer to Chapters 5, 6, and 7 on working with the terminal menu.
An EIA-232 serial connection is available via the Chain In port on the rear
panel of the ATLAS_800. The ATLAS_800 provides the Front Panel menus
to a VT-100 type terminal. The following Step/Action table provides instruc-
tions for setting up the ATLAS_800 for VT-100 terminal mode.
ATLAS 800 User Manual
Action
61200180L1-1