Designing The Dedicated Map For Example 2; Figure 8-3. Dedicated Map Overview Example; Table 8-1. Connections And Ports - ADTRAN ATLAS 800 User Manual

Chapter 8. Dedicated Maps Terminal Menu
EXAMPLE 2
T1-A: DS0 1-8 Voice; DS0 9-24 Data
T1-B: DS0 1-8 Voice; DS0 9-24 Data
T1-C: DS0 1-8 Voice; DS0 9-24 Data

Designing the Dedicated Map for Example 2

Name ATLAS
T1: Controller T1
Data A Slot 0 Port 1
T1: Controller T1
Data B Slot 0/Port 2
T1: Quad T1/PRI
Data C Slot 1/Port 1
8-6
CREATING A DEDICATED MAP
A Dedicated Map defines connections for dedicated bandwidth between
ports, and grooms and cross-connects bandwidth between T1 ports. Any
ATLAS port supporting dedicated bandwidth can be mapped to any other
port supporting dedicated bandwidth (see the example in Figure 8-3).
The example shown in Figure 8-3 contains three T1s (T1-A, T1-B, T1-C) sup-
porting dedicated bandwidth from three remote sites. Each T1 includes
DS0s for data and voice. At the central site (ATLAS), each incoming DS0 car-
rying data is mapped to a separate V.35 port and connected to the router.
DS0s carrying voice are collected together (groomed) and sent to the PBX
over a single T1 (T1-D).
In designing a Dedicated Map, you must first determine what connections
to make and which ports to involve. (For T1 ports, you must also decide
which DS0s to use). Then, you must configure the ports. Finally, you must
define the appropriate connections. The remainder of this chapter provides
step-by-step procedures for creating a sample Dedicated Map based on the
connections and ports given in Table 8-1.
800 Port DS0s
_
9-24
RBS Off
9-24
RBS Off
9-24
RBS Off
ATLAS 800 User Manual
V.35 A: Data
V.35 B: Data
V.35 C: Data
ATLAS 800
T1-D: 1-24 Voice

Figure 8-3. Dedicated Map Overview Example

Table 8-1. Connections and Ports

Name ATLAS
_
V.35 - A Quad V.35
Slot 2/Port 1
V.35 - B Quad V.35
Slot 2/Port 2
V.35 - C Quad V.35
Slot 2/Port 3
Router
PBX
800 Port DS0s
N/A
N/A
N/A
61200180L1-1