ADTRAN ATLAS 800 User Manual page 106

Chapter 9. Dial Plan Terminal Menu
»» Outgoing Caller ID
»» Source ID
»» Swap ANI/DNIS
9-12
Write security: 3; Read security: 5
Inserts a called ID based on the following selections.
Send as
ATLAS forwards whatever ID it receives (including None).
provided
Substitute if
ATLAS inserts a User-defined ID value if no value is re-
not present ceived.
ID
Presentation
ID Number
Substitute
ATLAS always inserts the User-defined ID in place of the val-
always
ue received.
ID
Presentation
ID Number
Simplifies the creation of a Dial Plan in applications where the criteria for
switching calls to a certain end point is a function of which end point origi-
nated the call. Keep in mind the following:
• Default value = 0. The default ID for all end points is 0 and for all
Accept # s is 0. With default values, all calls are routed based only on
the dialed number.
Multiple end points can have the same Source ID .
•
• When creating the call accept list, specify a Source ID as well as a dialed
number or range of dialed numbers to accept.
Say, for example, that an application requires all calls originating from
Port 1 of the T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. You would assign a unique Source ID (e.g., 7) to Port 1 of the module,
and then configure Port 4 to only accept calls from that unique Source ID (7).
Swaps the ANI and DNIS numbers received from the Network. ANI (Auto-
matic Number Identification) is the billing number of the calling party, and
DNIS (Dialed Number Identification Service) is the called party number.
This swap causes the ATLAS switchboard to use ANI to route the call.
The Accept # in the Dial Plan must use the ANI number, not the
DNIS number.
ATLAS 800 User Manual
Sends to the Network control information for
the presentation of Caller ID ( Presentation
Allowed; Presentation Restricted; Number
Not Available ).
Value for Caller ID to be sent to the Network
(i.e., 256 963 8020).
Same as above.
Same as above.
61200180L1-1