System Utilization; System Selftest - ADTRAN ATLAS 800 User Manual

Chapter 6. Terminal Menu and System Control
»» Load and Use
Config
»» Save Config
Remotely
» System Utilization
» System Selftest
»» Selftest Run
»» Status
»» View Selftest Log
6-16
Write security: 3; Read security: 5
Retrieves the configuration file specified in the TFTP Server Filename
field from the server. To start this command, enter Y to begin or enter N to
cancel.
If you execute this command, the ATLAS_800 retrieves the
configuration file, reboots, then restarts using the new configuration.
Write security: 3; Read security: 5
Saves the configuration file specified in TFTP Server Filename to the
server identified in TFTP Server IP Address . To start this command, enter
Y to begin or enter N to cancel.
Before using this command, you must have identified a valid TFTP
server in TFTP Server IP Address .
Write security: 0; Read security: 0
Displays statistics related to the internal operating system of the ATLAS.
Please check with Tech Support before attempting to use this feature.
Write security: 3; Read security: 5
Initiates a system self-test consisting of memory tests and data integrity
tests for each installed module.
Self-tests disrupt data flow.
Write security: 3; Read security: 5
Activates the self-test. To confirm self-test activation, press y ; to cancel the
self-test press n .
Write security: 3; Read security 5
Indicates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
Read security: 5
Displays time-stamped log of the tests conducted and the Pass/Fail results.
Self-tests verify data integrity and processor control to each port. Each port
is looped back and a data pattern is sent and tested. The result of the self-
test on each installed port is listed with Pass/Fail results. A typical test log
is shown in Figure 6-5. The log includes the following additional fields.
Idx
Index number of the log
Time
Time and date log created
ATLAS 800 User Manual 61200180L1-1