Figure 9-9. Remote Access And Video Conferencing Setup - ADTRAN ATLAS 800 User Manual

Example 3
61200180L1-1
Remote Access and Video Conferencing Dial Plan
A corporate office has T1 RBS service for voice but wants to add a PRI for
video conferencing and remote access. The office would like to use the PRI
for all functions, but it still wants to use the incoming BRI to supply added
bandwidth. The office wants to provide BRI lines to the video equipment,
provide a PRI to the remote access server (RAS), and send a T1 RBS to the
PBX (see Figure 9-9).
PRI-A
PRI-A
Network BRI-B
BRI-C

Figure 9-9. Remote Access and Video Conferencing Setup

For this example, the user termination BRI lines (D, E, F) each have a specific
phone number. The PRI serving the RAS has an 8-number hunt group, and
the T1 to the PBX uses DID. Assume that all calls originating from the PBX
to 1-900 numbers are restricted. Also, assume that the network termination
BRI lines (A, B, C) only allow outgoing calls to other local corporate offices
for video conferencing. The numbers fall in the range of 888-0100 to
888-0120. The following Step/Action Tables and numbered tables provide
information on setting up this example.
Instructions for Configuring the Ports for Example 3
Step
Prior to setting up the Dial Plan, you must configure the Controller
1
T1/PRI interfaces.
This configuration action only brings up the T1 transport; set the
2
BRI configuration (SPID and phone number) as part of the Dial
Plan.
ATLAS 800 User Manual
Chapter 9. Dial Plan Terminal Menu
BRI-D (888-1001)
BRI-E (888-1002)
BRI-F (888-1003)
ATLAS 800
PRI-B (888-1010 x8)
T1-A (RBS821-8xxx [x24] xDID)
Action
Video Conf.
RAS
PBX
9-21