Connect The Printer Cable - Canon imagePROGRAF W2200S Setup Manual

Connect the Printer Cable

Important
1
2
3
Note
3-24
Installing the Software
z If you intend to use a parallel port connection for a printer already set for a USB
connection, use the printer operation panel to change the interface setting to
Æ
Centronics. ( P.1-32)
z The printer cannot be connected via the parallel port and USB port or IEEE1394
port at the same time.
z The printer should be connected via any interface other than the parallel port when
printing high quality photographs or large document files.
If the computer is switched on, shut down Windows to switch the
computer off.
If the printer is on, hold down the Power button for over 2 seconds
and release it when the Online lamp starts to flash.
After the printer displays "Please Wait..." the printer goes off.
Connect one end of the cable to the parallel (Centronics) port on the
back of the printer, then lock the clips on both sides of the connector.
z The printer is equipped with a floating internal structure, so when you connect the
printer cable if the connector moves slightly this does not indicate anything
abnormal.
et Media
Cancel Job/
Utility etup
Reset/Enter
Power
Online Ink Replace
Online Message