Canon imagePROGRAF W2200S Setup Manual page 104

3
TIEEE1394 Connection
1
2
3-36
Installing the Software
Connect the USB cable B connector (square) to the USB port on the
back of the printer, then connect the USB cable A connector (flat) to a
USB port on the Macintosh.
Ensure that the connector is inserted completely.
Printer back
If the Macintosh is switched on, switch it off.
If the printer is on, hold down the Power button for over 2 seconds
and release it when the Online lamp starts to flash.
After the printer displays "Please Wait..." the printer goes off.
et Media
Cancel Job/
Utility etup
Reset/Enter
Power
Online Ink Replace
Online Message
Computer