Setting With The Garo Device Setup Utility; Checking The Printer Mac Address - Canon imagePROGRAF W2200S Setup Manual

Setting with the GARO Device Setup Utility

If you are using Windows, you can use the GARO Device Setup Utility to
set the network information.

Checking the Printer MAC Address

For the network settings you need the printer MAC address (the number
used to identify the built-in network interface board).
Follow the procedure below to perform an Ext. I/F Print so you can check
the MAC address. Before printing, make sure A4 or Letter size paper is
loaded in Cassette 1.
Important
z Always load A4 or Letter size paper in Cassette 1. If a smaller size is loaded, it
may smear ink inside the printer and onto other media.
z You do not need to select the media size on the operation panel. The media is force
fed from Cassette 1 to print the pattern.
1
Press the Power button to switch the printer on.
After a few seconds "Ready" is displayed in the operation panel and the
Online lamp lights.
2
Press the Online button to switch the Online lamp off.
The printer is set offline.
et Media
Cancel Job/
etup
Utility
Reset/Enter
Power
Online Ink Replace
Online Message
et Media
Cancel Job/
etup
Utility
Reset/Enter
Power
Online Ink Replace
Online Message
Setting with the GARO Device Setup Utility
2-3