Connecting The Interface Cable - Canon imagePROGRAF W2200S Setup Manual

Connecting the Interface Cable

Before starting the printer driver installation, connect the Macintosh and the
printer with the interface cable. Do the connection for a USB connection,
IEEE1394 connection, or network connection, whichever is suited for your
Macintosh.
To set up an IEEE1394 port connection, you need a Macintosh equipped
with an IEEE1394 (FireWire) port and running Mac OS 9.04 or later.
Important
z USB port and IEEE1394 port cannot be used at the same time.
TUSB Connection
1
If the Macintosh is switched on, switch it off.
2
If the printer is on, hold down the Power button for over 2 seconds
and release it when the Online lamp starts to flash.
After the printer displays "Please Wait..." the printer goes off.
et Media
Cancel Job/
etup
Utility
Reset/Enter
Power
Online Ink Replace
Online Message
Installing a Macintosh Connection
3-35