Installing The Motion Detector; Testing The Motion Detector - NexxTech 49110000 Owner's Manual

Installation

Installing the Motion Detector

• Attach the Motion Detector to a wall at a height of 5 to 6 ft. using the mounting bracket
and screws provided.
• Point the Motion Detector so that it looks slightly downwards.
• Set the slide switch (on the back) to position 1 for instant triggering for maximum
sensitivity or position 2 to trigger only after two movements have been sensed.
Tamper switch
(under battery compartment lid)

Testing the Motion Detector

• Set the slide switch on the Motion Detector to position 1.
• Press and hold the TEST button for about a second (until
the LED flashes twice) and then release it.
• Wait 20 seconds for the Motion Detector to settle.
• Walk in front of the Motion Detector. The indicator LED
lights each time it senses movement. Check the coverage
area and reposition the sensor as required.
• Press the TEST button to return to normal operating
mode.
Note: The Motion Detector will automatically return to
normal operating mode after approximately 2 minutes.
9 ˚ 0
5 6 - t f
18
3 0 4 - 0 t f