Controlling Lights And Appliances - NexxTech 49110000 Owner's Manual

Controlling Lights and Appliances

If you install one or more Lamp Modules (sold separately - see next page), you can control
lights around your home from the Console. When the Console is in its normal state it
displays HOME CONTROL in the display. Simply press the number button on the Console
corresponding to the number set on the module and then press On or Off on the Console's
control panel to control the light connected to the module.
You can also control lights set to your Security LIGHTCODE from the Light On and
Light Off buttons on the Keyfob Remote. These buttons on the Keyfob Remote control
lights connected to Nexxtech TM Home Automation Modules that are set to the Security
LIGHTCODE you set in the Console. (See page 26).
Also, any lights connected to Modules that are set to your Security LIGHTCODE flash on
and off when the alarm trips. The lights will stay on after an alarm until you turn them off,
either from the Console, or from the Keyfob Remote.
These lights also blink on for a second when the alarm is armed (from the Console) in the
ARM HOME Mode (or when armed from the keyfob Remote). The lights turn on for the exit
delay time when the alarm is armed from the Console in the ARM AWAY Mode.
Controls lights connected
Press both buttons
to Lamp Modules that are
at the same time
set to the Security LIGHT
to activate
CODE you set in the
the panic alarm.
Console (see page 26).
35