Table of Contents
Advertisement
Battery Information
Door/Window Sensors and Motion Detectors
Battery Replacement
If a zone has not reported in to the Console during the last four hours, the display will show
PROBLEM and the appropriate zone number when you try to arm the system. This is most
likely caused by dead batteries in the Motion Detector or Door/Window Sensor for that
zone.
As with the remotes, as long as the batteries have not completely failed they may be
replaced with fresh batteries without the need to reinstall the Motion Detector or Door/
Window Sensor. After removing the old batteries the new batteries must be fitted within 30
seconds to ensure that the code is retained.
Testing the Door/Window Sensor
Once the batteries have been replaced, the Door/Window Sensor should be tested as
follows:
• Make sure the system is NOT armed.
• Open the door or window with the sensor attached. The Console chimes to acknowledge
and the zone # is displayed on the LCD.
• If you don't hear a chime, re-register the Door/Window Sensor, as described on page 13
Testing the Motion Sensor
To test the Motion Detector:
• Make sure the system is armed.
• Press the TEST button on the back of the Motion Detector. The alarm trips. Press disarm
on the Keychain Remote.
• If the alarm doesn't trip, re-register the Motion Detector, as described on page 16.
Clearing Remotes & Sensors from the Console
If you suspect that a neighbor's system is causing false alarms, or if you need to reinstall
remotes, Door/Window Sensors, and Motion Detectors for any other reason, you can
clear all sensors and remotes from the Console's memory by following the steps on page
25. Before reregistering your remotes, Door/Window Sensors, and Motion Detectors you
should reinitialize them - remove the batteries, press a button for 5 seconds then refit the
batteries. Then follow the steps to reinitialize the unit (pages 12, 13, or 16 as appropriate).
39
Advertisement
Table of Contents
