Troubleshooting
PROBLEM
If the system does not arm.
Console displays PROBLEM followed by
Zone number when you try to arm it.
SOLUTION
• Check that the indicator on the Remote
turns on when you press ARM. Replace
the batteries and re-register the
Remote with the Console if necessary.
One of the sensors/motion detectors has
not reported in, in the last 4 hours.
Check that the batteries in the sensor/
motion detector are good.
Check if a protected door or window is
open.
If you need to arm the system and want to
ignore a sensor/motion detector which is
not functioning:
1. Press CLEAR on the Console while the
problems is being displayed.
2. Then press ARM on the Remote. The
problem zone is not protected but all
other zones are armed.
40