Installation; Main Console - NexxTech 49110000 Owner's Manual

Installation

Main Console

Attaching Cables
A telephone cord terminated at each end with an RJ11 connector is provided for telephone
connection. If possible, the Console should be connected to its own telephone line to
ensure that the line cannot be busy when the Console attempts to dial out. For applications
where this is not practical, the Console may also share a line with an existing telephone
using a 'T' adapter (not included).
Note: The Security Console is not designed to operate with an RJ31X type telephone
connection.
Open the lid on the Console and attach the
power supply cord to the connector labeled
power supply (see above). Plug the power
supply into any convenient AC outlet.
NOTE: you must use the power supply
that came with the Security System. The
power supply contains circuitry required
to control Nexxtech
CANNOT replace it with a regular 8V DC
power supply.
modules, so you
TM
PRESS THEN ENTER YOUR PIN. THEN USE
TO STEP THRU MENU ITEMS. THEN PRESS OK
TO SELECT ITEM. OR PRESS NUMBERS BELOW.
- Install Sensors & Remotes
1. INSTALL
2. SET C LOC K - Enter time of day
- Store up to 6 phone numbers
3. PHONE NUMS
- Record or Replay your message
4. MESSAG E
- Change your 4 Digit P.I.N.
5. NEW PIN
6. MEMORY - Sensor, Remote, Timer, Master
C LEAR
- Chime, Siren, H Code, L Code
7. OPTIONS
- Entry, Exit, Dial, Answer delays
8. DELAYS
9. SET TIMER - Set ON/OFF Timers
CLEAR GIVES OPTION TO LEAVE MENU
6
Attach the power
supply cord here.
Attach the phone
cord here.
Hard Wired Inputs.
Tamper Switch