Setting The Phone Numbers - NexxTech 49110000 Owner's Manual

Installation

Setting the Phone Numbers

Press either of the Menu up/down buttons. The display then shows ENTER PIN (Personal
Identification Number) in the top line.
The default PIN is 0000, press 0000 on the keypad. This clears the top line and shows *
for each number entered.
This takes you to the first level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
Press an up or down menu button until you reach the PHONE NUMS menu, and then
press OK to go to the screen below (or press 3 to go into the PHONE NUMS menu ):
Press an up or down Menu button to select the desired sub-menu:
PHONE 1
PHONE 2
PHONE 3
PHONE 4
PHONE 5
PHONE 6
Press OK at the desired number (1-6). The display shows SET PH1, SET PH2, etc. Enter
the phone number, up to 16 digits. off/pm gives a pause between numbers. Press OK.
This takes you to the next phone number to be stored.
Press Clear to back out of the menu. If you press Clear while entering numbers, before
you've finished setting the phone number, it clears the numbers. If you press Clear after
you finished entering the phone number and pressed OK, you are asked to confirm, 1.
YES, 2 NO. Press 1 to take you back to the HOME CONTROL screen. Press 2 to stay in
INSTALL mode.
Armed
ENTER PIN
12:00 am
Power
Battery
Armed
****
12:00 am
Power
Battery
Armed
1. INSTALL
Power
Battery
Armed
3. PHONE NUMS
Power
Battery
21
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away