Installing Door/Window Sensors - NexxTech 49110000 Owner's Manual

Installation

Installing Door/Window Sensors

• Attach the Door/Window Sensor to the wall using the mounting screws provided.
• Fit the Door/Window Sensor as high as possible at the top of the door/window.
• Make sure the arrows on the magnetic and the Door/Window Sensor are facing each
other and that they separate cleanly when the door or window is opened.
• To protect two doors or windows close to each other, use the Door/Window Sensor with
an additional set of magnetic switch contacts as shown in the diagrams above.
• Set the DELAY slide switch (inside the Sensor) to MIN to always trigger the alarm
instantly (for windows), or to MAX to trigger the alarm after a preset entry delay when the
system is armed in the AWAY mode (for doors).
The numbers 1 –32 in the display refer to up to 32 "zones." These represent up to 30 Door/
Window Sensors and/or Motion Detectors you install, plus the 2 hard wired zones. The
numbers show open zones, problem zones and bypassed zones by being displayed as
steady on (door or window open), slow flash (there's a problem with that zone) or fast flash
(that zone has been bypassed). Attempting to arm with an open or problem zone makes
the Console beep continuously and it will display in words on the display what the cause is,
but only for one zone at a time. Bypassing the zone (by pressing the Clear button) moves
on to the next problem zone, if there is one.
Ideal location
Sliding window
*
Remove shorting link
before installing hard
wired magnetic contacts.
Two doors or windows
(requires accessory
magnetic switch pair)
Note: when you add a magnetic switch
to a sensor you can register it with the
console as its own zone, e.g., the sensor
itself can be zone 1 and the extra magnet
zone 2. See previous page.
15
*
*