Using The System; Arming And Disarming The System - NexxTech 49110000 Owner's Manual

Using the System

Arming and Disarming the System

Arming the System
Press ARM HOME on the Console to arm all Door/Window Sensors instantly. Motion
Detectors will not trip the system when it is armed in the ARM HOME mode.
Press ARM AWAY to arm all Door/Window Sensors and Motion Detectors. This arms the
system after a set delay. The delay will be what you specified as the EXIT DELAY on page
27 (1 minute default). If you arm the system in the AWAY mode you will also have an entry
delay when you enter your home before the alarm trips, to give you time to disarm it. This
delay will be what you specified for your ENTRY DELAY on page 27 (30 second default).
Pressing ARM on the Keychain remote always arms in the AWAY mode, but arms instantly.
Disarming the System
Pressing DISARM on the Keychain remote disarms the system instantly. The zone that
was violated is shown in the display. To remove this press Arm and Disarm again.
To disarm from the Console: Enter your 4 digit PIN (Personal Identification Number) this
will be 0000 unless you changed it (see page 24).
Entering the PIN clears the top line and shows * for each number entered.
If the unit was armed, (in either ARMED HOME or ARMED AWAY modes) it will disarm
when the PIN is entered, and return to the time display, with DISARMED in the top line.
Armed
ENTER PIN
12:00 am
Power
Battery
Armed
****
12:00 am
Power
Battery
Armed
DISARMED
Power
Battery
32
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away