Setting The Clock - NexxTech 49110000 Owner's Manual

Installation

Setting the Clock

Press either of the Menu up/down buttons. The display then shows ENTER PIN (Personal
Identification Number) in the top line.
The default PIN is 0000, press 0000 on the keypad. This clears the top line and shows *
for each number entered.
This takes you to the first level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
Press an up or down menu button until you reach the SET CLOCK menu, and then press
OK (or press 2 to go directly to the screen below):
Enter the time by pressing the digits on the Console's keyboard. Then press AM or PM.
Then press OK.
Press Clear to back out of the menu. If you press Clear while entering numbers, before
you're finished setting the clock, it clears the numbers. If you press Clear after you've set
the time and pressed OK, you are asked to confirm, 1. YES, 2 NO. Press 1 to take you
back to the HOME CONTROL screen. Press 2 to stay in INSTALL mode.
Armed
ENTER PIN
12:00 am
Power
Battery
Armed
****
12:00 am
Power
Battery
Armed
1. INSTALL
Power
Battery
Armed
2. SET CLOCK
4:00 pm
Power
Battery
20
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away