Problem Zones; If There's A Problem - NexxTech 49110000 Owner's Manual

Using the System

Problem Zones

If There's a Problem

If a door or window is open and you try to arm the system the display looks as below.
Where ZONE 9 is the door or window that's open.
If a Door/Window Sensor or Motion Detector has not reported in within the last 4 hours
and you try to arm the system the display shows:
If a Door/Window Sensor has been tampered with, e.g. the cover is open, and you try to
arm the system the display shows:
For all the above situations, press the Clear (Bypass) button to bypass the problem zone
and to let you arm the system. After pressing Bypass the next problem zone is displayed,
(if there is more than one).
You cannot arm the system when there is a problem zone unless you fix the problem, or
bypass the zone. If you try to arm the system while there's a problem with one or more
zone you will hear a repetitive "trouble alarm" to alert you that you need to bypass or fix
the problem zone(s).
Note also, if the Console itself has been tampered with, i.e. the door to the upper right of
the display is open, the problem must be fixed (close the door) before you can arm the
system. Note if the system is armed and this door is tampered with, the alarm trips.
If you bypass a zone and then arm the system, that zone stays bypassed until you disarm
the system.
Armed
OPEN
ZONE 9
Power
Battery
Armed
PROBLEM
ZONE 9
Power
Battery
Armed
TAMPER
ZONE 9
Power
Battery
33
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away