NexxTech 49110000 Owner's Manual page 41

Troubleshooting
PROBLEM
If you hear a repetitive trouble alarm when
you try to arm the system, and it does not
arm.
If the alarm trips when you enter the
house before you have time to disarm it.
Lights will not turn on or off from the ON or
OFF buttons on the Keychain Remote.
SOLUTION
Check the Console's display. If a door or
window is open, its zone # will indicate
there's a PROBLEM.
• Press DISARM. Check each Door/
Window Sensor is working properly and
that no doors or windows are open.
Then arm the system.
Or:
• While the trouble alarm is sounding,
press CLEAR on the Console to
bypass the problem zone (the display
shows that it has been BYPASSED).
Then arm the system again.
• Or if the display shows TAMPER, check
the cover on the Door/ Window Sensor
for that zone.
• Or check that the upper right lid on the
Console it closed.
Arm the system in the AWAY mode.
• Be sure you set the correct SECURITY
LIGHT Code in the Console, see pages
26 and 35.
• Be sure the light you are trying to
control has its on/off switch in the on
position. Be sure its bulb is good.
• Plug the Module into another outlet
near the Console.
• Check that the indicator on the Remote
comes on when you press a button.
Replace batteries and re-register
remote if necessary.
• Check the dials on the Modules.
41