Installation
Motion Detector Setup
Initializing Motion Detector
Remove the cover on the front of the Motion Detector and install 2 x
AA alkaline batteries (not included) in the compartment. Replace the
cover.
Press and hold the TEST button on the back of the Motion Detector
for 3-4 seconds and then release it. This initializes the Motion
Detector and picks a random code that is used when it is registered
with the Console. Place the unit face down, so that it won't see any motion during the
registering process below.
Registering the Motion Detector with the Console
Press either of the Menu up/down buttons. The display then shows ENTER PIN (Personal
Identification Number) in the top line.
The default PIN is 0000, press 0000 on the keypad. This clears the top line and shows *
for each number entered.
This takes you to the first level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
Press OK and the display looks like this:
Armed
ENTER PIN
12:00 am
Power
Battery
Armed
****
12:00 am
Power
Battery
Armed
1. INSTALL
Power
Battery
Armed
1. INSTALL
ZONE
Power
Battery
16
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away
Home
Arm
Away