MacDon R85 Operator's Manual page 124

Figure 7.20: Cutterbar Filler Plug Locations
9. Locate one of the two filler plugs along the top of the
cutterbar. Refer to Figure
Locations, page 116
10. Clean around either filler plug (A) and remove one plug
with an 8 mm hex Allen L-key.
NOTE: Rotate disc to expose filler plug if
necessary.
11. Add lubricant to cutterbar through filler hole (A). See
Section 7.4 Recommended Fluids and Lubricants,
page 102.
IMPORTANT
DO NOT overfill the cutterbar.
cause overheating and damage to or failure of the
cutterbar will occur.
12. Install the filler plug that was removed.
13. Close cutterbar door(s). See Section
Doors, page 30.
14. Start engine and raise header off blocks.
15. Engage header safety props.
16. Remove blocks and lower header.
17. Stop engine and remove key from ignition.
18. Disengage header safety props.
19. Start engine and Lower the header fully.
169455
MAINTENANCE AND SERVICING
7.20: Cutterbar Filler Plug
Overfilling can
5.5 Cutterbar
116
Rev. E