Maintenance Schedule/Record - MacDon R85 Operator's Manual

7.5.1 Maintenance Schedule/Record

Action:
 Hour meter reading


First use
100 hours or annually
Conditioner drive
Inspecting the Conditioner Drive

Belt, page 138.
Bevel gearbox lube level - see
Lubrication and Servicing Intervals,

page 109.
End of season
10 hours or daily
Hydraulic hoses and lines - see
Hydraulic Hoses and Lines, page

145.
Cutter blades, deflectors, and discs
- see 7.6.1 Inspecting the Cutterbar

Discs, page 118.
25 hours
Roll universal shafts- see

Lubrication and Servicing, page
Cutterbar driveline universals- see
 7.5.5 Lubrication and Servicing,
page 107.
50 HOURS
Cutterbar lube first 50 and 150 hours
▲
- see 7.5.8 Lubricating the Cutterbar,
page 113.
Bevel gearbox lube level first 50 and
▲ 150 hours - see
and Servicing Intervals, page
169455
MAINTENANCE AND SERVICING
 - Check
Service date
Serviced by
Refer to Section
Refer to Section
belt - see
7.5.7
Refer to section
7.8.1
NOTE: A record of daily maintenance is not normally
required, but is at the Owner/Operator's discretion.
7.5.5
107.
7.5.7 Lubrication
109.
 - Lubricate
7.5.2 Break-In Inspections, page
7.5.3 Preseason/Annual Service, page
7.5.4 End-of-Season Service, page
104
▲ - Change
106.
106.
107.
Rev. E