Replacing A Spindle Key - MacDon R85 Operator's Manual

Replacing a Spindle Key

Follow these steps to replace a spindle key:
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
1. Lower header to ground, shut off engine, and
remove key.
2. Open cutterbar doors. Refer to Section
Doors, page 30.
CAUTION
Cutter blades have two cutting edges. Exercise
caution when working around the blades. Blades
are sharp and can cause serious injury.
gloves when handling blades.
3. Remove disc (A) from failed spindle. Refer to Section
Removing a Disc, page
4. Using a 34 mm socket wrench, remove nut (A) and
washer (B) from spindle.
169455
MAINTENANCE AND SERVICING
5.5 Cutterbar
Wear
119.
Figure 7.46
Figure 7.47
Figure 7.48
133
Rev. E