MacDon R85 Operator's Manual page 70

5. Raise lever (A) and undo cinch straps (C).
6. Move hose (B) to store on header.
7. Install caps on connectors and hose end (if equipped).
8. At the header, disconnect electrical connector by
turning collar counterclockwise and pulling connector
to disengage.
9. Disconnect drive couplers (A) and (B) and case drain
coupler (C) on header.
10. Move hose bundle from header and locate on
windrower left side (cab forward) with hoses in
support (B).
11. Rotate lever (A) clockwise and push to engage bracket.
12. Locate electrical harness through support (B) and
attach cap to electrical connector (C).
169455
OPERATION
Figure 5.71
Figure 5.72
A - Pressure
C - Case Drain
Figure 5.73
62
B - Return
Rev. E