MacDon R85 Operator's Manual page 63

4. Disconnect electrical harness at connector (A).
5. If couplers and coupler lock are installed on lines,
proceed as follows. Otherwise, proceed to step
Detaching the Header (M205 Windrowers), page
6. Disconnect 1/2 in. (12.7 mm) hose (B) from windrower
coupler and remove lynch pin (A).
7. Open up coupler lock (A).
8. Remove lock from couplers (B).
169455
OPERATION
13.,
56.
Figure 5.55
Figure 5.56
Figure 5.57
55
Rev. E