Installing The Control Panel Assembly - Dell Olympus O-T600 Installation And Service Manual

Figure 113. Removing the information tag
Next steps
1. Install the control panel

Installing the control panel assembly

Prerequisites
Follow the safety guidelines listed in
Steps
1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
Figure 114. Installing the information tag
2. To install the information tag, push the information tag into the control-panel slot.
3. Connect the control panel cable and the control panel USB cable to the control panel assembly.
4. Align and insert the control panel into the control panel slot in the chassis.
5. Secure the control panel to the chassis by using the screw.
6. Connect the control panel cable and the control panel USB cable to the system board.
assembly.
Safety instructions on page 27.
Installing and removing system components 119