Table of Contents
Advertisement
Figure 88. Installing the M.2 SSD module
Next steps
1. Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2.
Install the air
shroud.
3. Follow the procedure listed in
Optional MicroSD or vFlash card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate
IDSDM/vFlash module, see the
2. Hold the MicroSD card and remove it from the slot.
After working inside your system
Safety instructions
Before working inside your system
System board jumpers and connectors
on page 28.
on page 27.
on page 28.
section.
Installing and removing system components
101
Advertisement
Table of Contents
