3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to install the drive.
Figure 31. Installing a drive into the drive carrier
Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
remove the front bezel.
3.
Remove the drive
carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
2. Lift the 3.5 inch drive adapter out of the 3.5 inch drive carrier.
Safety instructions
on page 27.
Installing and removing system components
39