Table of Contents
Advertisement
Installing the system board
Prerequisites
Follow the safety guidelines listed in
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the post, incline the system board, and lower the system board into the chassis.
3. Holding the system board holder, push the system board toward the back of the system until the release pin clicks into place.
Figure 119. Installing the system board
4. Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1. Replace the following:
a.
Trusted Platform Module (TPM)
b.
Memory modules
c.
Processors and heat sink modules
d.
Internal USB key
e.
vFlash/IDSDM module
f.
Integrated storage controller card
g.
Expansion
cards, if installed
h.
Cooling fan
assembly, if applicable
i.
Expansion card holder
j.
GPU card holder
124
Installing and removing system components
Safety instructions
on page 27.
Advertisement
Table of Contents
