Figure 26. Removing a drive blank
Next steps
1.
Install a drive
or
drive
blank.
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 27.
2. If installed,
remove the front bezel.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 27. Installing a drive blank
Installing and removing system components
35