Table of Contents
Advertisement
NOTE:
For a processor greater than 150 W, you need to use high performance heat sink and processor module.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Using a Torx #T30 screwdriver, loosen the screws on the heat sink in the order below:
a. Loosen the first screw three turns.
b. Loosen the second screw completely.
c. Return to the first screw and loosen it completely.
2. Pushing both blue retention clips simultaneously, lift the processor and heat sink module (PHM).
3. Set the PHM aside with the processor side facing up.
Figure 65. Removing the processor and heat sink module
Next steps
1.
Install the
PHM.
80
Installing and removing system components
Safety instructions
Before working inside your system
on page 27.
on page 28.
Advertisement
Table of Contents
