Dell Olympus O-T600 Installation And Service Manual page 131

3. Lay the system on a flat, stable surface.
4. Remove the system cover.
5. If installed, remove the system feet
Steps
1. Remove the system top cover.
2. Remove the control-panel assembly.
3. Install the rack slide cover by performing the following steps:
a. Slide the rack slide cover between the system's side cover and the chassis.
b. Slide the rack slide cover toward the back of the system until the tabs on rack slide cover locks with the tabs extending
from the chassis.
Figure 126. Installing the rack slide cover
4. Install the control panel assembly.
5. Attach the mylar to cover the screw hole on the chassis where one of the system rear feet was installed while in the tower
mode.
Figure 127. Attaching the mylar cover
6. Install the rack ears by performing the following steps:
a. Align the three screw holes on the rack ears with the screw holes on the top and the bottom of system.
b. Using a Phillips #2 screwdriver, secure the rack ears to the system.
130 Installing and removing system components
or caster wheels.