Installing A Memory Module - Dell Olympus O-T600 Installation And Service Manual

page of 136

/ 136
Contents
Table of Contents
Bookmarks

Table of Contents

2. Follow the procedure listed in

CAUTION:

To prevent data loss and potential damage to your system, ensure that your system, LEDs on

system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before removing the NVDIMM-N

battery.

Remove the air shroud.

WARNING:

Allow the memory modules to cool after you power off the system. Handle the memory modules by

the card edges and avoid touching the components or metallic contacts on the memory module.

CAUTION:

To ensure proper system cooling, memory module blanks must be installed in any memory socket that

is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.

Steps

1. Locate the appropriate memory module socket.

CAUTION:

Handle each memory module only by the card edges, ensuring not to touch the middle of the

memory module or metallic contacts.

2. Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.

3. Lift and remove the memory module from the system.

Figure 63. Removing a memory module

Next steps

Install the memory module.

2. If you are removing the memory module permanently, install a memory module blank. The procedure to install a memory

module blank is similar to that of the memory module.