Table of Contents
Advertisement
Control panel
Removing the control panel assembly
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Using the Phillips #2 screwdriver, remove the screw that secures control panel to the system.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION:
Do not use excessive force when removing the control panel cables as it can damage the connectors.
3. Slide the control panel out of the system.
4. To remove the information tag, perform the following steps:
a. Locate and press the tabs on the information tag.
b. Push the information tag out of the slot to remove it from the control panel.
Figure 84. Removing the control panel assembly
NOTE:
Retain the information tag to replace it in the new control panel.
Next steps
1.
Replace the control panel
Installing the control panel assembly
Prerequisites
Follow the safety guidelines listed in
Steps
1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
104
Installing and removing system components
Safety
instructions.
Before working inside your
assembly.
Safety
instructions.
system.
Advertisement
Table of Contents
