Installing The Control Panel Assembly - Dell E36S Series Owner's Manual

Installing the control panel assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove the bezel.
4. Keep the Phillips #2 screwdriver ready.
Steps
1. Insert the control panel assembly into the guide slot and slide it downward to lock the assembly into place.
2. To secure the control panel, insert and tighten the screws to the chassis.
3. Route the control panel and USB data cables through the chassis clip.
4. Connect the control panel and USB data cables to the system board.
Figure 16. Installing the control panel assembly
1. screw (3)
3. control panel assembly guide (2)
52 Installing and removing system components
Safety instructions on page 42.
Before working inside your system on page 43.
2. control panel assembly
4. control panel assembly guide slot (2)