Figure 33. Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
Next steps
1.
Install the drive
carrier.
2. If removed,
install the front
Removing a 2.5 inch drive from a 3.5 inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in
2.
Remove the 3.5 inch drive adapter from the 3.5 inch drive
NOTE:
A 2.5 inch drive is installed in a 3.5 inch drive adapter, which is then installed in the 3.5 inch drive carrier.
Steps
1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 screwdriver to remove the drive.
2. Remove the 2.5 inch drive from the 3.5 inch drive adapter.
bezel.
Safety instructions
on page 27.
carrier.
Installing and removing system components
41